Mitsubishi MOTORS SHOGUN SPORT, Owner'S Manual

Page: 157 / 501

Combination headlamps and dipper switch
5-60 Instruments and controls
5
E00506301428
The high-beams flash when the lever is
pulled slightly (2), and will go off when it is
released.
When the high-beam is on, the high-beam
indicator lamp in the instrument cluster will
illuminate.
E00528902014
This function turns on the position and tail
lamps for approximately 30 seconds after the
UNLOCK switch on the remote control trans-
mitter is pressed when the combination head-
lamps and dipper switch is in the “OFF” or
“AUTO” position (for vehicles equipped with
the automatic lamp control).
E00529001770
This function turns on the headlamps in the
low beam setting for approximately 30 sec-
onds after the ignition switch is turned to the
“OFF” position or the operation mode is put
in OFF.
1. Turn the combination headlamps and dip-
per switch to the “OFF” or “AUTO” posi-
tion (for vehicles equipped with the
automatic lamp control).
2. Turn the ignition switch to the “LOCK”
position or put the operation mode in
OFF. Also, if a key was used to start the
engine, remove the key from the ignition
switch.
3. Within 60 seconds of turning the ignition
switch to the “LOCK” position or putting
the operation mode in OFF, pull the turn-
signal lever towards you.
Headlamp flasher
NOTE
 The high-beams can also flash when the
lamp switch is OFF.
 If you turn the lamps off with the headlamps
set to high-beam, the headlamps are auto-
matically returned to their low-beam setting
when the lamp switch is next turned to the
“
” position.
Welcome light
NOTE
 While the welcome light function is operat-
ing, perform one of the following operations
to cancel the function.
• Press the LOCK switch on the remote con-
trol transmitter.
• Turn the combination headlamps and dip-
per switch to the “ ” or “ ” position.
• Turn the ignition switch to the “ON” posi-
tion or put the operation mode in ON.
 It is possible to modify functions as follows:
• The headlamps can be set to come on in the
low beam setting.
• The welcome light function can be deacti-
vated.
For further information, please contact your
authorised MITSUBISHI MOTORS dealer.
Coming home light
BK0240501EN.book 60 ページ ２０１６年１１月１０日 木曜日 午前１０時３５分