Mitsubishi MOTORS SHOGUN SPORT, Owner'S Manual

Page: 419 / 501

How to change a tyre
8-12 For emergencies
8
6. Remove the wheel nuts with the wheel nut
wrench, then take the wheel off.
7. Clean out any mud, etc. on the hub sur-
face (G), hub bolts (H) or in the installa-
tion holes (I) in the wheel, and then mount
the spare wheel.
8. Turn the wheel nuts clockwise by hand to
initially tighten them.
[Normal wheels and aluminium spare
wheel]
Tighten the wheel nuts until the flanges of
the wheel nuts touch the wheel and the
wheel is not loose.
[Steel spare wheel]
NOTE
 This jack is a 2 stage expansion type.
WARNING
 Stop jacking up the vehicle as soon as the
tyre is raised off the ground. It is danger-
ous to raise the vehicle any higher.
 Do not get under your vehicle while using
the jack.
 Do not bump the raised vehicle or leave it
sitting on the jack for a long time. Both
are very dangerous.
 Do not use a jack except the one that came
with your vehicle.
 The jack should not be used for any pur-
pose other than to change a tyre.
 No one should be in your vehicle when
using the jack.
 Do not start or run the engine while your
vehicle is on the jack.
 Do not turn the raised wheel. The tyres
still on the ground could turn and make
your vehicle fall off the jack.
CAUTION
 Handle the wheel carefully when changing
the tyre, to avoid scratching the wheel sur-
face.
WARNING
 Mount the spare wheel with the valve stem
(J) facing outboard. If you cannot see the
valve stem (J), you have installed the
wheel backwards.
Operating the vehicle with the spare wheel
installed backwards can cause vehicle
damage and result in an accident.
BK0240501EN.book 12 ページ ２０１６年１１月１０日 木曜日 午前１０時３５分