Microcom 360C, Operator'S Manual

Page: 252 / 297

251
12
Click [Next] on the [IP Protocol Type] screen.
13
Click [Complete].
·
Setting the Filter Operations
1
Click [OK] in the [IP Filter List] window.
2
In [Security Rules Wizard], select the new IP filter in the list, and click [Next].
3
Click [Add] on the [Filter Action] screen.
4
Click [Next] in [Filter Action Wizard].
5
On the [Filter Action Name] screen, enter [Name] and [Description], and click [Next]. On
the [Filter Action General Options] screen, select [Negotiate security], and click [Next].
6
On the [Communicating with computers that do not support IPsec] screen, select [Do
not allow unsecured communication], and click [Next].
7
On the [IP Traffic Security] screen, select [Custom], and click [Setup].
8
Configure the settings in the [Custom Security Method Settings] window, and click [OK].
·
Specify the same values as specified in [ESP Encryption Algorithm], [ESP Authentication
Algorithm], [AH Authentication Algorithm], and [Lifetime] in "Phase2 Proposal" in
"Configuring the Machine."
9
Click [Next] on the [IP Traffic Security] screen.
10
Select [Edit Properties], and click [Complete].
·
Assigning an IP Security Policy
1
To enable key PFS, select [Use session key perfect forward secrecy (PFS)] in the [Filter Action
Properties] window.
2
To perform IPSec communication with an IPv6 global address, select [Accept unsecured
communication, but always respond using IPsec].
3
Click [OK].
4
Select the new filter operation, and click [Next].
5
On the [Authentication Method] screen, select the authentication method, and click
[Next].