Meler PS 20 NON STOP+, Instruction Manual

Page: 26 / 100

FOCKE MELER GLUING SOLUTIONS INSTALLATION
3-8
Connecting external inputs and outputs
Warning: Risk of electric shock. Carelessness may cause injuries or death.
1. Disconnect the unit’s power.
2. Open the front door of the electric cabinet by giving the fastening screw
a 1/4 turn.
3. Run the signal cable (max. Ø14 mm) through the bushing at the rear of
the unit (P) and attach it to the interior fitting, making sure the cable
reaches the corresponding terminals/connectors.
4. Connect the two cable wires to the corresponding terminal/connector.
The polarity of the connection must be correct:
5. Make sure that the cables are properly secured by the terminal’s
screws.
6. Check that the cable is correctly connected and that its passage
through the electric cabinet presents no risk of jamming, being cut or
any other accidental damage.
7. To assign the function to be performed by the connected signal, see
point ‘4 Use / Settings Menu / Configuration of input and output
signals’’.
P