Meler PS 20 NON STOP+, Instruction Manual

Page: 58 / 100

FOCKE MELER GLUING SOLUTIONS
4-32
MELTER OPERATION
‘Automatic pumping block’ disabled
When this function is disabled, whenever an event forces the unit to change
to ERROR mode, STANDBY mode or OFF mode, it will automatically return
to READY mode once the conditions are met again. You do not have to press
STOP. The red LED will remain off.
Example: The unit is in RUNNING mode. At this moment, the
temperature is not OK, and after the programmed time has passed, the
unit changes to ERROR mode. When the temperature is OK again, the
unit automatically changes to READY mode.
Warning: It is always possible to put the unit in STOPPED mode by pressing
STOP. The red LED will light up. In this case, even if permitted by the
conditions, it will not be possible to return to READY mode until you press
STOP again and the LED turns off.
Warning: Whenever the ‘Automatic pumping block’ function is disabled, it
is recommended for the ‘ON/OFF’ or ‘OFF Pumping’ signal of the unit to be
connected to the main machine, so that this signal can be used to enable the
unit again in a controlled manner.
PISTÓN
HMI : S02001100 v1.0.106
TC : S02200100 v1.0.084
IO : S02102100 v1.0.106
10 min
85 °C 60 s
Modbus
B: 57600 Node: 10
2.2 Extra Settings
Inside device temperature alarm
Off after reset
Screen saver
Sound on alarm
Pumping autolock
Press to
activate
pumping
STOPPED
MODE
READY
MODE
Press to
deactivate
pumping