215794
76
Revision A
1009066
CXXX
MXXX
WINDROWER SETUP?
NO/YES
A
B
C
Figure 5.41: M155 Programming Buttons Shown
–
M155
E4
Similar
1.
Turn the ignition key to the RUN position, or start the
engine.
2.
Press PROGRAM (A) and SELECT (C) simultaneously on the
CDM to enter programming mode.
•
WINDROWER SETUP? appears on the upper line.
•
NO/YES appears on the lower line.
3.
Press right arrow (B) to select YES. Press SELECT (C).
•
SET KNIFE SPEED? appears on the upper line.
1022629
CXXX
MXXX
NO/YES
SWATH COMPR INSTALL?
B
A
Figure 5.42: M155 Swath Compressor Controls Shown
–
M155
E4
Similar
4.
Press SELECT (B) until SWATH COMPR INSTALL? appears on
the upper line.
•
NO/YES appears on the lower line.
5.
Press right arrow (A) to select YES. Press SELECT (B).
6.
Press SELECT (B) until CALIBRATE SENSORS appears on the
upper line. NO/YES appears on the lower line.
7.
Press right arrow (A) to select YES. Press SELECT (B).
•
TO CALIBRATE SELECT appears on the upper line.
•
HEADER HEIGHT appears on the lower line.
8.
Press right arrow (A) to scroll through choices until SWATH
COMPR HT appears. Press SELECT (B).
•
SWATH SENSOR CAL appears on the upper line.
•
SWATH UP TO START appears on the lower line.
1031050
B
A
Figure 5.43: Swath Compressor Switch
9.
Press switch (A) on the console to raise the swath
compressor.
•
CALIBRATING SWATH appears on the upper line.
•
The messages FORM UP and HOLD (HOLD will be
flashing) appear, and will remain on the lower line until
the system has received a signal from the fully-raised
swath compressor.
•
The messages SWATH FORM UP and DONE
(accompanied by a buzzer tone ) will appear on the
lower line when the calibration procedure is complete.
•
SWATH SENSOR CAL appears on the upper line.
•
PRESS SWATH DOWN appears on the lower line.
