215794
105
Revision A
1011817
CXXX
EXXX
VIEW ENGINE CODES?
NO/YES
C
C
B
A
D
Figure 5.104: Engine Codes
10. Press right arrow (C) to select YES. Press SELECT (D).
11. Press left arrow (B) or right arrow (C) to cycle through the
last ten recorded engine error codes until EXIT ENGINE
CODES appears.
12. Press right arrow (C) to select YES. Press SELECT (D).
13. Press PROGRAM (A) to exit programming mode or press
SELECT (D) to proceed to the next diagnostic option.
5.8.2
Enabling or Disabling Header Sensors
You can selectively enable or disable specific header sensors using the windrower
’
s cab display module (CDM).
NOTE:
•
The header must be attached to the windrower to perform this procedure. The CDM automatically adjusts its
programming for each header.
•
Disabled sensors generate the flashing message SENSOR on the CDM during regular operation, indicating that output
from this sensor has been suppressed.
To enable or disable certain header sensors:
1011786
CXXX
EXXX
WINDROWER SETUP?
NO/YES
A
B
C
Figure 5.105: CDM Programming Buttons
1.
Turn the ignition key to the RUN position, or start the
engine.
2.
Press PROGRAM (A) and SELECT (C) on the CDM to enter
programming mode.
•
WINDROWER SETUP? will appear on the upper line.
•
NO/YES will appear on the lower line.
3.
Press SELECT (C) until DIAGNOSTIC MODE? will appear on
the upper line.
•
NO/YES will appear on the lower line.
4.
Press right arrow (B) to select YES. Press SELECT (C).
•
VIEW ERROR CODES? will appear on the upper line.
