215794
149
Revision A
8.2
Attaching D Series or D1 Series Draper Header
M155
E4
Self-Propelled Windrowers are compatible with D and D1 Series Draper Headers.
1008824
Figure 8.4: M155
E4
Draper Header Hydraulics
If installing an HC10 Hay Conditioner, Reverser kit (MD #B4656)
is recommended. If necessary, obtain the recommended kit and
install it in accordance with the instructions supplied with
the kit.
The procedure for attaching a D or D1 Series Draper Header to
the windrower differs slightly depending on the configuration of
the windrower. Proceed to the relevant topic:
•
8.2.1 Attaching D Series or D1 Series Draper Header
Hydraulic Center-Link with Self-Alignment, page 149
•
8.2.2 Attaching D Series or D1 Series Draper Header
Hydraulic Center-Link without Self-Alignment, page 154
8.2.1
Attaching D Series or D1 Series Draper Header
–
Hydraulic Center-Link with
Self-Alignment
The windrower may be equipped with an optional self-aligning hydraulic center-link, which allows the Operator to control
the vertical position of the center-link from the cab.
NOTE:
Draper header boots must be installed onto the windrower lift linkage before beginning this procedure. For instructions,
refer to
8.1 Attaching Header Boots, page 147
DANGER
To prevent bodily injury or death from the unexpected startup of the machine, always stop the engine and remove the
key from the ignition before leaving the operator
’
s seat for any reason.
1.
Shut down the engine, and remove the key from the ignition.
1000754
A
B
Figure 8.5: Header Leg
2.
Remove hairpin (A) from pins (B), and remove the pins from
both header legs.
