215794
160
Revision A
8.3
Attaching A Series Auger Header
M155
E4
Self-Propelled Windrowers are compatible with A30D, A30S, and A40D Auger Headers.
1000777
Figure 8.33: M155
E4
and A40D Auger Header
Windrowers equipped with A Series hydraulics have four
header-drive hoses on the left side.
The attachment procedure varies depending on the type of
center-link installed on the windrower. Refer to the following
instructions based on the type of center-link installed on your
windrower:
•
8.3.1 Attaching A Series Auger Header
Link with Self-Alignment, page 160
•
8.3.2 Attaching A Series Auger Header
Link without Self-Alignment, page 166
8.3.1
Attaching A Series Auger Header
–
Hydraulic Center-Link with Self-Alignment
The windrower may be equipped with an optional self-aligning hydraulic center-link, which allows the Operator to control
the vertical position of the center-link from the cab.
DANGER
To prevent bodily injury or death from the unexpected startup of the machine, always stop the engine and remove the
key from the ignition before leaving the operator
’
s seat for any reason.
1.
Shut down the engine, and remove the key from the ignition.
1000778
A
B
C
Figure 8.34: Header Boot
2.
Remove hairpin (A) from clevis pin (B) and remove the
clevis pin from header boots (C) on both sides of the
header.
