215794
121
Revision A
1011784
CXXX
EXXX
ACTIVATE FUNCTIONS?
NO/YES
B
A
Figure 5.141: Functions
5.
Press SELECT (B) until ACTIVATE FUNCTIONS? appears on
the upper line.
•
NO/YES will appear on the lower line.
6.
Press right arrow (A) to select YES. Press SELECT (B).
•
ACTIVATE HEADER HT will appear on the upper line.
1011787
CXXX
EXXX
DISC DRV SPD XXXX
D 0 P 0
- +
D
D
B
A
C
E
Figure 5.142: Disc Drive
7.
Press SELECT (E) until DISC DRV SPD XXXX appears on the
upper line.
8.
Press and hold HAZARD button (C).
•
Press left arrow (B) to decrease the disc speed.
•
Press right arrow (D) to increase the disc speed.
IMPORTANT:
Do
NOT
overspeed the disc drive.
NOTE:
Ensure that the disc drive is working properly.
9.
Release HAZARD button (C). The disc drive will stop.
10. Press PROGRAM (A) to exit programming mode or press
SELECT to proceed to the next header function option.
5.9.8
Testing Double Windrow Attachment Drive Activate Function Using Cab
Display Module
The cab display module (CDM) can be used to test the Double Windrower Attachment (DWA) drive circuit, rather than
using the controls on the operator
’
s station.
IMPORTANT:
Do
NOT
overspeed the DWA drive. Overspeeding can lead to vibration, belt failures, or other overspeeding-related
problems.
NOTE:
•
The DWA must be attached to the windrower and must have been activated under the WINDROWER SETUP menu. For
more information, refer to
5.3.8 Configuring Double Windrow Attachment Controls, page 71
•
The engine must be running to perform this procedure.
DANGER
Ensure that all bystanders have cleared the area.
