215794
57
Revision A
Chapter 5:
Cab Display Module
Although the other procedures in this instruction are intended to be followed in the order in which they are listed, the
sections in this chapter can be referred to in any order according to your specific requirements.
5.1
Cab Display Module
–
Configuration Functions
Use the cab display module
’
s (CDM) configuration functions to set up the windrower, to change the appearance of the
CDM itself, to enter diagnostic mode, and to calibrate the header sensors.
1011481
A
B
C
D
E
F
Figure 5.1: CDM
A - Side Display
B - Main Display
C - Select Switch
D - Menu Item Scroll Forward
E - Menu Item Scroll Backward
F - Program Switch
Side Display
: Displays the current revision level of the windrower
’
s operating software.
•
Upper line
–
C### (CDM software revision level)
•
Lower line
–
E### (Windrower control module [WCM] software revision level)
Main Display
: Displays potential menu items and the current selection.
NOTE:
The current selection will flash.
•
Upper line
–
Menu item
•
Lower line
–
Current selection
Select Switch
: Pressing this switch along with the PROGRAM switch puts the CDM into programming mode. Press SELECT to
accept the highlighted menu item and to advance the selection to the next item.
Menu Item Scroll Forward
: Displays the value of the currently selected menu item.
•
Push the MENU ITEM SCROLL FORWARD button to scroll forward
•
Hold the MENU ITEM SCROLL FORWARD button down to scroll rapidly
