215794
69
Revision A
1011760
CXXX
EXXX
WINDROWER SETUP?
NO/YES
A
B
C
Figure 5.25: CDM Programming Buttons
1.
Turn the ignition key to the RUN position, or start the
engine.
2.
Press PROGRAM (A) and SELECT (C) simultaneously on the
CDM to enter programming mode.
•
WINDROWER SETUP? will appear on the upper line.
•
NO/YES will appear on the lower line.
3.
Press right arrow (B) to select YES. Press SELECT (C).
•
SET KNIFE SPEED? will appear on the upper line.
1011807
HEADER INDEX MODE?
CXXX
EXXX
REEL & CONVEYOR
D
C
B
A
Figure 5.26: Header Index Mode
4.
Press SELECT (D) until HEADER INDEX MODE? appears on
the upper line.
•
REEL & CONVEYOR or REEL ONLY will appear on the
lower line.
5.
Press left arrow (B) or right arrow (C) to set HEADER INDEX
mode. Press SELECT (D).
6.
Press PROGRAM (A) to exit programming mode or press
SELECT (D) to proceed to the next WINDROWER SETUP
option.
5.3.6
Setting Return to Cut Mode
Enabling the return to cut feature in the cab display module (CDM) allows the Operator to make use of height and
(optionally) tilt position presets. The return to cut feature can be configured by accessing the RETURN TO CUT MODE sub-
menu in the WINDROWER SETUP menu.
NOTE:
The header
MUST
be attached to the windrower to perform this procedure. The cab display module (CDM) automatically
adjusts its programming for each header. For more information, refer to
8 Attaching Headers to M Series Windrower, page
1.
Turn the ignition key to the RUN position, or start the engine.
