215794
191
Revision A
8.5.2
Attaching R2 Series Rotary Disc Header
–
Hydraulic Center-Link without Self-
Alignment
If the M155
E4
Self-Propelled Windrower is equipped with a hydraulic center-link that lacks self-alignment capability, the
Operator will have to manually attach the hydraulic center-link
’
s hook to the R216 Rotary Disc Header
’
s center pin.
DANGER
To prevent bodily injury or death from the unexpected startup of the machine, always stop the engine and remove the
key from the ignition before leaving the operator
’
s seat for any reason.
1.
Shut down the engine, and remove the key from the ignition.
1030516
A
B
C
Figure 8.109: Header Support
2.
Remove hairpin (A) from clevis pin (B), and remove the pin
from header support (C).
3.
Repeat the previous step on the other side of the header.
1029675
B
A
C
Figure 8.110: Header Support
4.
Lift header support (A) and place 2 x 4 in. blocks (B) under
the header support. A total of four 2 x 4 in. blocks (B) will
be necessary to raise the boot up into field position. Ensure
the boot
’
s bottom edge (C) is parallel with the ground.
Repeat for the opposite side.
NOTE:
Do
NOT
stack blocks (B) crosswise; doing so can make the
header unstable. Stack blocks (B) so that the edges of the
blocks are flush with each other.
