215794
104
Revision A
5.8
Troubleshooting Windrower Problems
The cab display module (CDM) is a useful troubleshooting tool, providing information about sensor status and error codes.
5.8.1
Displaying Windrower and Engine Error Codes
The cab display module (CDM) stores any error codes that occur. Follow this procedure to review the CDM
’
s stored error
codes.
1022036
CXXX
EXXX
WINDROWER SETUP?
NO/YES
A
B
Figure 5.101: CDM Programming Buttons
1.
Turn the ignition key to the RUN position, or start the
engine.
2.
Press PROGRAM (A) and SELECT (B) simultaneously on the
CDM to enter programming mode. Press SELECT (B).
•
WINDROWER SETUP? will appear on the upper line.
3.
Press SELECT (B) until DIAGNOSTIC MODE? appears on the
upper line.
•
NO/YES will appear on the lower line.
1011785
CXXX
EXXX
DIAGNOSTIC MODE?
NO/YES
A
B
Figure 5.102: Diagnostic Functions
4.
Press right arrow (A) to select YES. Press SELECT (B).
5.
VIEW ERROR CODES? will appear on the upper line.
•
NO/YES will appear on the lower line.
6.
Press right arrow (A) to select YES. Press SELECT (B).
•
VIEW WINDRWR CODES? will appear on the upper line.
•
NO/YES will appear on the lower line.
1027487
CXXX
EXXX
VIEW WINDRWR CODES?
NO/YES
C
A
B
Figure 5.103: Windrower Codes
7.
Press right arrow (A) to select YES. Press SELECT (C).
•
The most recent error code will appear.
8.
Press right arrow (A) or left arrow (B) to cycle through the
last ten recorded windrower error codes until EXIT
WINDROWER CODES appears.
9.
Press right arrow (A) to select YES. Press SELECT (C).
•
VIEW ENGINE CODES will appear on the upper line.
•
NO/YES will appear on the lower line.
