215794
115
Revision A
5.9.4
Testing Knife Drive Circuit Using Cab Display Module
It may be necessary to use the cab display module (CDM) to test the knife drive circuit, rather than using the controls on
the operator
’
s station.
IMPORTANT:
Do
NOT
overspeed the header
’
s knife drive. Overspeeding can lead to vibration, belt failures, or other overspeeding-
related problems.
NOTE:
The header must be attached to windrower to perform this procedure.
DANGER
Ensure that all bystanders have cleared the area.
1022036
CXXX
EXXX
WINDROWER SETUP?
NO/YES
A
B
Figure 5.127: CDM Programming Buttons
1.
Start the engine.
2.
Press PROGRAM (A) and SELECT (B) simultaneously on the
cab display module (CDM) to enter programming mode.
Press SELECT (B).
•
WINDROWER SETUP? will appear on the upper line.
1011785
CXXX
EXXX
DIAGNOSTIC MODE?
NO/YES
A
B
Figure 5.128: Diagnostic Functions
3.
Press SELECT (B) until DIAGNOSTIC MODE? appears on the
upper line.
•
NO/YES will appear on the lower line.
4.
Press right arrow (A) to select YES. Press SELECT (B).
