215794
16
Revision A
CAUTION
The front legs rest on the trailer deck on skid shoes. Ensure there are no obstructions preventing the skid shoes from
sliding rearwards, and watch carefully while dragging the unit to ensure the skid shoes do not slide sideways towards
the edge of the trailer deck.
6.
Drag the windrower rearwards off of the carrier.
7.
Remove the chains and back off the forklift.
8.
Check the windrower for damage, and inspect the shipment for missing parts.
2.2.2
Method 2: Lifting from Trailer Deck
The windrower can be lifted from the transport vehicle using one forklift of sufficient lifting capacity.
DANGER
Equipment used for unloading must meet or exceed the specified requirements. Using inadequate equipment may
result in chain breakage, vehicle tipping, or machine damage.
Table 2.4 Lifting Vehicle Requirements
Minimum Capacity
2
4994 kg (11,000 lb.)
Minimum Fork Length
198.1 cm (78 in.)
IMPORTANT:
Forklifts are normally rated for a load located 610 mm (24 in.) ahead of the back end of the forks. To determine the forklift
capacity at 122.2 cm (48 in.), check with your forklift distributor.
WARNING
Ensure the forks are secure before moving the trailer away from the load. Stand clear when lifting.
1.
Move the trailer onto level ground and block the trailer
wheels.
2.
Set the forklift tines to the widest possible setting.
1005739
A
Figure 2.3: Windrowers on Trailer
3.
Position the forklift on the left or right side of the trailer,
and position forks (A) under the windrower frame.
NOTE:
The windrower
’
s center of gravity is approximately
139.7 cm (55 in.) rearwards from the center of the
drive wheel.
WARNING
Ensure the forks extend beyond the far side of the frame.
4.
Lift the windrower until it is clear of the trailer deck.
5.
Back the forklift slowly away from the trailer until the
windrower is clear of the trailer deck.
6.
Lower the unit slowly to the ground. If the ground is soft,
place wooden blocks under the front shipping stands.
2.
At 122.2 cm (48 in.) from back end of forks.
