215794
13
Revision A
Chapter 2:
Unloading Windrower
Unload all windrower parts before beginning assembly. Carefully follow these procedures in the order in which they are
presented.
You can use one or two forklifts to unload the windrower. Refer to
2.1 Using Two Forklifts to Unload Windrower, page 13
or
2.2 Using One Forklift to Unload Windrower, page 15
.
2.1
Using Two Forklifts to Unload Windrower
The windrower can be unloaded from the transport vehicle using two forklifts with sufficient lifting capacity.
Figure 2.1: Two-Forklift Unloading Method
1005567
DANGER
To prevent injury to bystanders and to avoid striking them with machinery, do NOT allow people to stand in the
unloading area.
DANGER
Equipment used for unloading must meet or exceed the specified requirements. Using inadequate equipment may
result in chain breakage, vehicle tipping, or machine damage.
Table 2.1 Lifting Vehicle Requirements
Minimum Lifting Capacity at
122.2 cm (48 in.) from the Back
End of the Forks
2500 kg (5500 lb.)
Minimum Fork Length
1981 mm (78 in.)
