M-system 47DAC, Operating Manual

Page: 15 / 251

15 47DAC OPERATING MANUAL EM-9518-B Rev.4
■
DISPLAY
COMPONENT FUNCTION
Main display Indicates present, MAX and MIN values, parameters, setting values and error codes.
COMPONENT FUNCTION COMPONENT FUNCTION
Bargraph Indicates present signal level against the
scaled range. 20 LED segments divided by
10. (Refer to 7. SETTING BARGRAPH.) Sub display Indicates the present parameter ID, alarm
setpoints and bank No., or over- or under-
input with ‘S.ERR’ indication.
INDICATOR MODE FUNCTION
Status Measuring Indicates MAX or MIN value.
‘Max’ or ‘Min’ indicator turns on.
(Refer to 27. RETAINING MAX AND MIN VALUES.)
Indicates Forced Zero mode.
‘FZ’ indicator turns on.
(Refer to 26. FORCING THE PRESENT DISPLAY VALUE TO ZERO.)
Indicates Tare Adjustment mode.
‘TZ’ indicator turns on.
(Refer to 26. FORCING THE PRESENT DISPLAY VALUE TO ZERO.)
INDICATOR MODE FUNCTION INDICATOR MODE FUNCTION
Alarm Setting Indicates parameters in Alarm
Setting Mode.
(Refer to 9. BASIC ALARM SET-
TING.) Function Setting Indicates parameters in Scaling
Setting Mode.
‘Zro’ or ‘Spn’, and ‘Tch’ indicators
turn on in combination depending
on the parameters.
‘HH’, ‘H’, ‘L’ or ‘LL’ indicator blinks
corresponding to the P output
setting.
(Refer to 11.1 P OUTPUT.)
Teach Calibration
‘Zro’ or ‘Spn’ indicator turns on
and ‘Tch’ indicator blinks in red.
(Refer to 33.1 TEACH CALIBRA-
TION.)
Confirming
and configur-
ing alarm
setpoints ‘HH’, ‘H’, ‘L’ or ‘LL’ indicator blinks
in confirming and configuring
each alarm setpoint.
(Refer to 25. CONFIRMING
AND CONFIGURING ALARM
SETPOINTS.) ‘NG’ indicator blinks when a
parameter is within invalid range
while setting.
Confirming
and configur-
ing alarm
setpoints ‘NG’ indicator blinks when a
setpoint is within invalid range
while setting.
Measuring Indicates the comparison result
between alarm setting values and
present values.
‘HH’ indicator turns on when the
HH alarm is tripped.
‘H’ indicator turns on when the H
alarm is tripped.
‘L’ indicator turns on when the L
alarm is tripped.
‘LL’ indicator turns on when the
LL alarm is tripped.
‘P’ indicator turns on when none
of the other alarms is tripped. Measuring ‘Hld’ indicator turns on with the
HOLD signal ON with the event
trigger input or the BCD output.
(Refer to 21. SETTING EVENT
TRIGGER INPUT and 22. SET-
TING BCD OUTPUT.)
‘TG’ indicator turns on with the
TIMING signal ON with the event
trigger input.
(Refer to 21. SETTING EVENT
TRIGGER INPUT.)