188
47DAC OPERATING MANUAL EM-9518-B Rev.4
23.3 PARITY BIT
23.3.1 OPERATING PROCEDURE
NOTE
The following figures are display examples. The displays
depend on the settings.
1
Hold down Alarm/
↓
and Shift buttons at once for 3 seconds or
more to move on to Modbus Setting Mode.
• The device address is indicated.
• The SD indicates ‘EQP-NO’.
2
Press Alarm/
↓
or Scale/
↑
button to go to the parity bit setting.
• The parity bit is indicated.
• The SD indicates ‘PARITY’.
3
Press Shift and Up buttons to select the parity bit.
• Select one among ‘ODD’, ‘EVEN’ and ‘NONE’.
4
Press Alarm/
↓
or Scale/
↑
button to apply the new setting.
• And the next parameter setting is indicated.
NOTE
• Press Alarm/
↓
button, and the stop bit will be indicated (‘STOPBIT’ on the SD).
• Press Scale/
↑
button, and the baud rate will be indicated (‘B-RATE’ on the SD).
1,2,
4
2,4
1,3
3
Blinking
