89
normal mode.
Remote control
The XT1 remote control is able to arm/disarm the system or set it to home mode.
Product description:
1.
Arm button
Press this button for approx. 3 seconds to arm the system. A warning signal (long
beep) confirms this. Then you have a certain adjustable period to leave the
house, before the system is armed automatically.
If a window/door contact or tamper contact is still open, then system cannot be
armed at the first attempt, which is signaled by two brief signals.
2.
(+) button
If you keep this button pressed for minimum 3 seconds, the system will receive a
panic alarm and alert irrespective of the set mode.
3.
Arm/disarm button (Home button)
This button shows the arm/disarm icons. Activates the Home mode.
4.
Disarm button
Press this button to disarm the system. If the system is currently raising alarm,
this deactivates the siren/alarm as well. In case of a panic alarm however, the
alarm system needs to be deactivated via the web interface.
5.
LED indicator
The red LED lights up briefly every time you press a button (attempts
transmission to the control unit). If you press the panic button, the LED lights up
five times and then transmit the panic alarm.
6.
Battery cover
The remote control requires a CR2032 3 V 230 mAh lithium battery. The average
battery life is two years. The battery status is transmitted to the control unit with
each transmission.
Put the remote control into operation
1.
Use a coin to open the battery cover.
2.
Install the battery with the negative side facing down (flat side up).
3.
Close the battery cover.
4.
Open the main menu of the XT1 and open the menu “Sensors”
“Add”. Press
“Start”.
5.
Press one of the remote control buttons for approx. 3 seconds.
