108
Battery:
The repeater has a rechargeable internal Ni-MH 600 mAH 4.8 V battery, which works
as an emergency power back up for up to 30 hours in case of power failure. In this
case, the green LED remains on. The battery requires approx. 48 hours to load. A
signal is sent to control unit if the battery runs low.
Connect the wireless repeater to the control unit
1.
Connect the supplied power supply unit. The green LED will light up and the
repeater emits a long beep.
2.
Set SW1 to ON:
3.
Start the configuration page of the control unit, open the menu
Sensors
Devices
and click the item
“Add/Apply device”
.
4.
The repeater sounds a signal tone once and the red LED will light up for one
second, thus confirming the successful activation of the repeater.
5.
Set SW1 back to the OFF position.
Note:
The repeater is connected to the control unit, but there is no entry in the control
unit
.
To test whether the repeater is already connected to the control unit, repeat
steps 1 to 4. The
repeater emits two short signal tones to confirm the successful
connection.
Connect sensors to the repeater:
1.
Connect the supplied power supply unit. The green LED will light up and the
repeater emits a long beep.
2.
Set the SW1 switch to ON:
3.
Activate the test (learn) mode of the respective sensor by pressing the test button
as specified in the sensor manual.
4.
The repeater sounds a long signal tone and the red LED will light up for one
second. Repeat this process for all sensors to be amplified. (If a sensor was
already added, the repeater acknowledges this with two short signals.)
5.
Set SW1 back to the OFF position.
Additionally connect sensor to the control unit:
1.
If the sensor (with the weak signal strength) was already learned to the control
unit, you do not have to repeat this process. The repeater already amplifies the
sensor signal, which can be verified by means of a range test.
2.
Otherwise, proceed as usual via the menu
Sensors
Add sensors
Start
to
add a sensor to the control unit, after having connected the sensor to the
repeater. For detailed instructions, please refer to the respective sensor manual.
