![Lupus Electronics LUPUSEC-XT1 Manual Download Page 24](http://html1.mh-extra.com/html/lupus-electronics/lupusec-xt1/lupusec-xt1_manual_1950353024.webp)
24
time has elapsed. This applies to sensors with the “Home entry” setting only
with the system in Home mode.
during delay upon exit (Home mode)
Sounds an audio warning, when the Home mode is activated, during the time
specified in “Time settings”, until the time has elapsed.
Ring tone for entrance areas
Specify whether a signal tone is to sound, if an “entrance area” sensor is
released. This applies to sensors with the “Entrance area” setting only.
Further settings
Remote controls
To set, whether or not the LUPUSEC-XT1 alarm system is to notify the alarm
center if a remote control is used.
Forced arming
o
Off:
If the system is armed irrespective of failures (system errors, batteries,
power supply, open detectors or general status of detectors) with the
keypad or remote control, two brief tones sound to indicate a failure - the
system remains disarmed. If you arm the system again within 10 seconds,
the system will be armed irrespective of the failures.
Note
:
A list of the “failures” is shown on the web interface for about one second upon
arming.
o
On:
The system is armed directly with the keypad/remote control,
irrespective of failures in the system (tamper, battery, door open, etc.).