125
Activate/deactivate supervisor Jumper Switch (JP2)
7.
The supervisor mode is deactivated with Jumper 2 set to
ON
.
The supervisor mode is activated with Jumper 2 set to
OFF
(default setting)
.
Activate/deactivate microwave test Jumper Switch (JP3)
8.
The PIR/microwave sensor is in microwave test mode with Jumper 3 set to
ON
(see
Microwave test mode below
).
The microwave test mode is deactivated with Jumper 3 set to
OFF
(default
setting)
.
9.
Learn/Test button
Press this button to add the PIR/microwave sensor to the control unit or to start
the three-minute test mode.
10.
Battery compartment
A 3 V Lithium battery is required – model 1 CR123A.
11. Microwave range button
The arrow indicates the set range:
Turn the arrow
clockwise
to increase the detection range
(maximum 0-15 m)
Turn the arrow
counter clockwise
to reduce the detection
range (minimum 0-5 m)
The default setting is
minimum
.
12.
Tamper contact
The tamper contact is pressed against the bump on the back and thus closed.
13.
Installation notch / break-joint
Standby mode
After every motion detection, the PIR/microwave sensor goes into the standby mode
to save energy. Any other motion detection during this time resets the standby timer
to one minute.
Supervisor function:
With Jumper 2 activated and the PIR/microwave sensor in normal mode, the
supervisor signal is transmitted every 30 to 50 minutes. If the control unit does not
receive the supervisor signal from the sensor, this causes the control unit to show an
error message “Out of operation”.
Tamper contact
The tamper contact presses onto the mount on the back. With the PIR/microwave
motion detector properly mounted, the tamper contact is closed in normal operation.
As soon as the tamper contact opens, the sensor transmits the tamper alarm to the
control unit and the Transmitter LED lights up.
Break joint
Jumper On
The jumper bridges the two
pins.
Jumper Off
The jumper is removed or is on
one pin only.
