74
User PIN (default 1234) + Arm
(one long signal tone, the red Status LED lights
up).
2.
Disarm:
User PIN (default 1234) + Disarm
(2 signal tones, the blue Status LED lights up).
3.
Enable Home mode:
User PIN (default 1234) + Home
and then 1, 2, or 3 to activate the required Home
mode (three signal tones and the red Status LED flashes four times).
Note
:
If a system error is displayed (the third LED flashes), you can usually ignore it by
activating the Arm/Home mode again within ten seconds.
Alternatively, you can configure the control unit so that the status is always
changed irrespective of system errors via “Settings”
“Control unit”
“Settings”
“Forced arming” switch to “On”.
The keypad transmits its status “only” upon input. That is the reason why you can
see that the batteries are low, but not that they are empty!
Activate dual key functions:
The keypad can trigger panic alarm, fire alarm, or medical emergency alarm by
means of predefined shortcuts. Once activated, these shortcuts can be used
without
entering the PIN code
! To activate the dual keys, please proceed as follows:
Start the Test mode by entering the installer PIN code of the keypad (default 0000)
and then pressing the * button. The Power LED lights up in orange.
In the Test mode, press the following keys to activate the respective functions:
Activate dual key functions 1+3 (panic alarm): * + 2
Activate dual key functions 4+6 (fire alarm): * + 3
Activate dual key functions 7+9 (emergency alarm): * + 4
Activate all dual key functions: * + 5
Additional optional settings in Test mode:
Add the keypad to the control unit: * + 7
Change the installation PIN code: *+6
1.
Enter the current PIN code (default 0000).
2.
Press the Status
button. A long signal tone sounds.
3.
Enter the new four-digit PIN code.
4.
Press the # button to save the new PIN code.
Activate Arm/Home without PIN input: * + 8
Activate Arm/Home with PIN input: * + 9
To
exit the installation mode
, press the “Open lock key”
twice.
Reset:
If you forgot your PIN code, you can reset the keypad to the
factory settings
. For
this purpose, please proceed as follows:
1.
Open the housing, making sure not to trigger the tamper contact.
2.
Remove the batteries.
3.
Press and hold pressed the button 3, while you reinstall the batteries.
4.
Release the button 3.
