117
To put the wireless lock contact into operation, proceed as follows:
1.
Insert the supplied battery.
2.
Set the
DIP switch 1 to ON
as described.
3.
Connect the contacts of the lock contact cable to
terminal 6
.
4.
Close the housing.
5.
Open the configuration page of the control unit, open the
menu “Sensors”
“Add” and click Start.
6.
Press the test button of the wireless lock contact for about
one second.
7.
The configuration page of the control unit should list the
wireless lock contact.
8.
Add the wireless lock contact.
9.
You can test the signal strength in the Range menu. For that
purpose, go to the intended place of installation, press
Range test
Start in the control unit menu Sensors
Range and then press the Test button of the wireless lock
contact. The higher the indicated number the better the
reception (1-9).
10.
Open the sensor list, find the lock contact and click on “Edit”.
Note:
The XT1 control unit can exclusively show the status and trigger an alarm/exit delay
when opening. Only the XT2 control unit is able to arm/disarm the system when the
door is locked/unlocked.
