122
Switch no.
Position
Description
SW 1
ON
Learn / add mode
OFF
Normal Operation Standard)
SW 2
ON
Factory setting
OFF
Normal operation (default)
SW 3
OFF
System setting
MUST be
OFF
, as otherwise no function
SW 4
OFF
SW 5
OFF
Reserved
Put the tag reader into operation
Installation of the tag reader:
1.
Install the tag readers indoors only.
2.
Remove the front of the tag reader by unscrewing the lower screw.
3.
Use both screw holes to mark the drill holes at the wall.
4.
Make sure that the tamper contact of the tag reader lies flat on the ground.
5.
Tighten the tag reader.
6.
Insert the batteries. The Power LED lights up for a few seconds and a signal
sounds.
Add the tag reader to the control unit:
1.
Open the control unit menu and then the sub-menu Sensors
Add and click
Start.
2.
Start the installation mode by pressing the Arm or Disarm button and then
promptly setting switch 1 to ON. The Status LED starts flashing and one long
signal tone followed by two short signal tones sound.
3.
Press the Disarm button of the tag reader.
4.
The control unit indicates the tag reader as “Keypad” (XT1) or “Tag reader” (XT2).
5.
Add the tag reader to the control unit.
6.
Exit the learn mode of the control unit.
7.
Leave the installation mode of the tag reader by setting SW1 to OFF again, which
is acknowledged with four short signal tones. Then reinstall the front of the tag
reader by tightening the lower screw.
Note:
The installation mode ends automatically after five minutes at the latest. To restart the
installation mode, you need to set SW1 to ON again.
Add a tag to the tag reader:
1.
Start the installation mode by pressing the Arm or Disarm button and then
