73
o
Arming forced despite sensor failure reports
Error LED:
Orange LED flashes: system error, e.g.
o
No SIM card
o
GSM not ready
o
Open tamper contact
o
Control unit power failure
o
Sensor out of range
o
Open sensor
o
Sensor battery low
Battery:
The keypad requires a 1/2 AA 3 V 850 mAH lithium battery. The average battery
life is two years. If the battery is low, the orange Status LED on the keypad
flashes.
Put the keypad into operation
Installation of keypad:
1.
Remove the front cover from the keypad by unscrewing the lower screw.
2.
Two holes are located on the back of the keypad. Drill through them and then mark
the drill holes at the wall.
3.
Fasten the keypad.
4.
Attach the front cover.
Add keypad to control unit:
1.
Open the installation mode by entering the PIN code of the keypad (default 0000)
and then pressing the
*
key. The Power LED will light up in orange.
2.
Open the main menu of the control unit and then the sub-menu “Sensors”
“Add”. Click Start.
3.
Enter the sequence
*
+ 7 in the keypad. The keypad should emit a signal sound
and be displayed in the control unit.
If no audio signal sounds, the control unit was not able to receive the keypad
signal.
If the keypad is found, three short signals sound.
4.
Add the keypad to the control unit.
5.
Perform the range test. Start the range mode of the control unit and take the
keypad to its intended place of installation.
6.
Enter the sequence
*
+ 7 in the keypad.
7.
The control unit should display the actual signal strength.
8.
To
exit the installation mode
, press the “Open lock key”
twice. Only then,
you can arm and disarm the control unit with the keypad.
The keypad sounds a signal and the Power LED goes off after a short while.
Change PIN code to arm/disarm/home:
Go to Home
PIN codes to change these codes.
Change alarm system status with keypad:
1.
Arm:
