23
Delay upon exit (Home mode)
If the Home mode is activated e.g. via the keypad, you usually need time to
leave the premises. Specify this delay until an alarm can be triggered here.
Alarm duration
This item refers to the alarm duration of
all
integrated sirens. If an alarm is
triggered and the sirens activated, specify the maximum alarm duration. If the
control unit is disarmed again, the acoustic alarm goes off.
Note:
If a shorter alarm duration than in this menu item is defined by means of the DIP
switches (SW3+4) of an external siren, then the alarm of the external siren is aborted
prematurely. The other way round, the alarm duration of an external siren is aborted
prematurely with the alarm duration as described, if a longer (maximum) alarm
duration is defined by means of the DIP switches (SW3+4). If the alarm duration is
„deactivated“, the external sirens will become active for the duration defined with the
DIP switches (SW3+4).
Siren delay
Specifies the duration of the delay of all audible alarms internal siren +
external sirens). This function is deactivated by default.
Motion check
This function is the countdown timer (default: deactivated). If the defined time
elapses without being reset by a motion detector before, the XT1 control unit
will send a message to the alarm center (if set-up via contact ID).
Sensor check
Motion detectors and door contacts have a “Supervisor” function, which sends
data to the control unit at regular intervals to signal that the sensor is still
available and functioning. You can set this function here. If no “Supervisor”
signal is registered within the specified interval, the sensor is shown as “out of
service”.
Signal tones
during delay upon entry
Sounds an audio warning during the time specified in “Time settings”, until the
time has elapsed. This applies to sensors with the “Entrance area” setting
only.
during delay upon exit
Sounds an audio warning during the time specified in “Time settings”, until the
time has elapsed.
Note:
This function is active only for arming with keypad or remote control.
during delay upon entry (Home mode)
Sounds an audio warning during the time specified in “Time settings”, until the
