![Lupus Electronics LUPUSEC-XT1 Manual Download Page 79](http://html1.mh-extra.com/html/lupus-electronics/lupusec-xt1/lupusec-xt1_manual_1950353079.webp)
79
Note:
These three settings are transmitted only, but not permanently stored in this
menu. After their transmission, all three settings are ON again - but they were
stored in the sirens, after they transmitted the confirmation signal.
In addition, please observe that the configuration is transmitted to all currently
connected and active external sirens. If you want to configure several sirens
differently, you should install these sirens later or just disconnect these sirens
from the power supply temporarily. It is impossible to read out the current siren
configuration.
Battery:
The wireless indoor siren requires 4 D-cell alkaline batteries. The average battery life
is two years (depending on the usage).
Warning sounds and signals of the indoor siren:
Signal tone
Arm/Home
1 beep*
Disarm
2 beeps*
Arm (low battery)
5 beeps
Disarm (low battery)
5 beeps
Arm (tamper)
5 beeps
Disarm (tamper)
2 beeps*
Pre-alarm
3 seconds beep
Tamper alarm
Continuous beeps
Entrance/exit signal tone
Continuous beeps until time
has elapsed