77
Wireless indoor siren
Product description:
1.
Battery compartment
2.
DIP switches
3.
Tamper contact
4.
Mounting holes
Scope of delivery:
4 x dowels
4 x 1.5 V D alkaline battery
Put the wireless indoor siren into operation
1.
Remove the bottom of the wireless indoor siren by unscrewing the screw at the
bottom.
2.
Unscrew the four battery compartment screws and insert the supplied batteries. A
brief signal sounds.
3.
A blue switch bay with altogether seven switches is located in the middle of the
electronic component. By default, they are all set to OFF (down).
4.
The following table lists the functions of the switches:
SW1
Mode to add the siren to the control unit
OFF
Off
ON
On
SW2
Not occupied
SW3
SW4
Alarm duration
OFF
OFF
3 minutes (default setting)
ON
OFF
5 minutes (not allowed in Germany)
OFF
ON
10 minutes (not allowed in Germany)
ON
ON
One second (Test mode)
SW5
Not occupied
SW6
Reset memory
OFF
Normal
ON
Deletes memory
SW7
Sends a status signal to the control unit
OFF
Off
ON
On
5.
Start the control unit’s configuration page, open the menu “Sensors”
“Add” and
click “Start”.
6.
To put the wireless indoor siren into operation, set SW1 from OFF to ON. The
wireless indoor siren sounds a brief signal tone for confirmation.
7.
The control unit will now detect the wireless indoor siren and list it under
“Detected sensor”. If the siren is not found, repeat step 6.
