Lenovo System x3630 M4, Installation And Service Manual

Page: 308 / 1050

Step 8. Install the air baffle (see “Replacing the air baffle” on page 323).
Step 9. Install the PCI riser-card assembly (see “Replacing a PCI riser-card assembly” on page 237.
Step 10. If you have the optional hot-swap rear hard disk drive cage installed, rotate it down (see “Rotating
the optional hot-swap rear hard disk drive cage down” on page 181).
Step 11. Install the server top cover (see “Replacing the server top cover” on page 321).
Step 12. Install the power supplies.
Step 13. Reconnect the external cables; then, reconnect the power cords and turn on the peripheral devices
and the server.
Removing the hot-swap hard disk drive backplane
Use this information to remove the hot-swap hard disk drive backplane.
To remove the hot-swap hard disk drive backplane, complete the following steps:
Step 1. Read the safety information that begins in “Safety” on page v and “Installation guidelines” on
page 36.
Step 2. Turn off the server (see “Turning off the server” on page 26) and all attached peripheral devices.
Disconnect all power cords; then, disconnect all external cables as necessary to replace the device.
Step 3. Pull the drives or filler panels out of the server slightly to disengage them from the backplane
assembly.
Step 4. Remove the server top cover (see “Removing the server top cover” on page 320).
Step 5. Open the two cable retainer clips behind the fan cage to release the cabling.
Notes:
1. Based on the server configuration, the hot-swap hard disk drive backplane may appear as
either of the following.
2. You can refer to the internal cable routing section “Internal cable routing” on page 173 for
further details.
For eight 3.5-inch hot-swap drive backplane:
294
Lenovo System x3630 M4 Installation and Service Guide