Lenovo System x3630 M4, Installation And Service Manual

Page: 335 / 1050

Step 4. Loosen the two thumbscrews that secure the cover to the chassis.
Step 5. Press on the two blue grip points and slide the cover toward the rear; then, lift the cover off the
server. Set the cover aside.
000
000
00000
00000
00000
00000
00000
000000
000000
000000
Thumbscrew
Cover
Step 6. If you are instructed to return the server top cover, follow all packaging instructions, and use any
packaging materials for shipping that are supplied to you.
Replacing the server top cover
Use this information to replace the server top cover.
To install the server top cover, complete the following steps:
Step 1. Make sure that all cables, adapters, and other components are installed and seated correctly
and that you have not left loose tools or parts inside the server. Also, make sure that all internal
cables are correctly routed.
Step 2. Align the cover over the server (toward the rear of the server) until the cover edges slip into
position over the chassis.
Attention: Before sliding the cover forward, make sure that all the tabs on both the front, rear, and
side of the cover engage the chassis correctly. If all the tabs do not engage the chassis correctly, it
will be hard to Remove the server top cover in the future.
Step 3. Slide the cover forward toward the front of the server until the cover is completely closed.
Step 4. Tighten the thumbscrews on the rear of the cover to secure the cover to the chassis.
Chapter 6
.
Removing and replacing components
321