Lenovo System x3630 M4, Installation And Service Manual

Page: 333 / 1050

000
000
00000
00000
00000
00000
00000
System board
(9 screws)
Step 6. Install the USB embedded hypervisor flash device (see “Replacing a USB embedded hypervisor
flash device” on page 222).
Step 7. Install the system battery (see “Replacing the system battery” on page 258).
Step 8. Install the DIMMs (see “Replacing a memory module” on page 213).
Step 9. Install each microprocessor with its matching heat sink (see “Replacing a microprocessor and heat
sink” on page 309).
Step 10. Install the socket covers that you removed from the microprocessor sockets on the new system
board and place them on the microprocessor sockets of the old system board, if you have not
done so.
Step 11. Reconnect to the system board the cables that you disconnected in step 12 of “Removing the
system board” on page 313 (see “Internal cable routing” on page 173 and “System-board internal
connectors” on page 30 for more information).
Step 12. Install the air baffle (see “Replacing the air baffle” on page 323), making sure that all cables are
out of the way.
Step 13. Install any removed adapters into the particular PCI riser-card assemblies (see “Replacing an
adapter on the PCI riser-card assembly” on page 192 and “Replacing a ServeRAID adapter on
the PCI riser-card assembly” on page 216).
Step 14. Install the PCI riser-card assemblies (see “Replacing a PCI riser-card assembly” on page 237).
Step 15. If you had the optional hot-swap rear hard disk drive cage installed, insert it back into the server
(see “Replacing an optional hot-swap rear hard disk drive cage” on page 183).
Step 16. Install the server top cover (see “Replacing the server top cover” on page 321).
Step 17. Push the power supplies back into the server.
Step 18. Reconnect the external cables; then, reconnect the power cords and turn on the peripheral devices
and the server.
Step 19. Start the Setup utility and reset the configuration.
Chapter 6
.
Removing and replacing components
319