Lenovo System x3630 M4, Installation And Service Manual

Page: 119 / 1050

Clearing CMOS data does not affect the administrator password.
Administrator password
If an administrator password is set, you must type the administrator password for access to the full Setup
utility menu. You can use any combination of 6 to 20 printable ASCII characters for the password.
Attention: If you set an administrator password and then forget it, there is no way to change, override,
or remove it. You must replace the system board.
Using the Boot Manager program
Use this information for the Boot Manager.
The Boot Manager program is a built-in, menu-driven configuration utility program that you can use to
temporarily redefine the first startup device without changing settings in the Setup utility.
To use the Boot Manager program, complete the following steps:
Step 1. Turn off the server.
Step 2. Restart the server.
Step 3. When the prompt
<F12> Select Boot Device
is displayed, press F12. If a bootable USB mass
storage device is installed, a submenu item ( USB Key/Disk ) is displayed.
Step 4. Use the Up arrow and Down arrow keys to select an item from the Boot Selection Menu and
press Enter .
The next time the server starts, it returns to the startup sequence that is set in the Setup utility.
Starting the backup server firmware
Use this information to start the backup server firmware.
The system board contains a backup copy area for the server firmware. This is a secondary copy of the
server firmware that you update only during the process of updating the server firmware. If the primary copy
of the server firmware becomes damaged, use this backup copy.
To force the server to start from the backup copy, turn off the server; then, place the J2 jumper in the
backup position (pins 2 and 3).
Use the backup copy of the server firmware until the primary copy is restored. After the primary copy is
restored, turn off the server; then, move the J2 jumper back to the primary position (pins 1 and 2).
The Update Xpress System Pack Installer
The Update Xpress System Pack Installer detects supported and installed device drivers and firmware in the
server and installs available updates.
For additional information and to download the Update Xpress System Pack Installer, go to the ToolsCenter
for System x and BladeCenter at http://publib.boulder.ibm.com/infocenter/toolsctr/v1r0/ and click
UpdateXpress System Pack Installer .
Using the integrated management module II
The integrated management module II (IMM2) is a second generation of the functions that were formerly
provided by the baseboard management controller hardware. It combines service processor functions, video
controller, and remote presence function in a single chip.
Chapter 3
.
Configuration information and instructions
105