Lenovo System x3630 M4, Installation And Service Manual

Page: 59 / 1050

00000
00000
00000
00000
00000
Driver-tray
assembly
Drive handle
To remove a hot-swap hard disk drive, complete the following steps:
Step 1. Read the safety information that begins in “Safety” on page v and “Installation guidelines” on
page 36.
Step 2. Press the release latch on the side of the drive front.
Step 3. Grasp the handle and pull the hot-swap drive assembly out of the drive bay.
Note: You might have to reconfigure the disk arrays after you remove a hard disk drive. See the
RAID documentation on the LenovoServeRAID Support CD for information about RAID controllers.
If you have other devices to install or remove, do so now. Otherwise, go to “Completing the installation”
on page 87.
Removing a simple-swap hard disk drive
Use this information to remove a simple-swap hard disk drive from the server.
To remove a simple-swap hard disk drive, complete the following steps:
Step 1. Read the safety information that begins in “Safety” on page v and “Installation guidelines” on
page 36.
Step 2. Turn off the server (see “Turning off the server” on page 26) and all attached peripheral devices.
Disconnect all power cords; then, disconnect all external cables as necessary to replace the device.
Step 3. Remove the filler panel from the front of the server.
Step 4. Locate the release tab (blue) on the hard disk drive; then, while you press the release tab to the
right, grasp the handle and pull the drive out of the bay.
Chapter 2
.
Installing optional devices
45