Lenovo System x3630 M4, Installation And Service Manual

Page: 334 / 1050

• Set the system date and time.
• Set the power-on password.
• Reconfigure the server.
See “Using the Setup utility” on page 98.
Step 20. Either update the server with the latest RAID firmware or restore the pre-existing firmware from a
diskette or CD image (see “Updating the firmware ” on page 95).
Step 21. Update the UUID (see “Updating the Universal Unique Identifier (UUID)” on page 114).
Step 22. Update the DMI/SMBIOS (see “Updating the DMI/SMBIOS data” on page 116).
Removing and replacing consumable and structural parts
This section provides information for removing and replacing consumable and structural parts in the server.
Replacement of consumable parts and structural parts is your responsibility. If Lenovo installs a consumable
part or structural part at your request, you will be charged for the installation.
The illustrations in this document might differ slightly from the hardware.
Removing the server top cover
Use this information to remove the server top cover.
To remove the server top cover, complete the following steps:
Step 1. Read the safety information that begins in “Safety” on page v and “Installation guidelines” on
page 36.
Step 2. Turn off the server (see “Turning off the server” on page 26) and all attached peripheral devices.
Disconnect all power cords; then, disconnect all external cables as necessary to replace the device.
Step 3. If the server has been installed in a rack, press the two release latches on the front of the server
and remove the server out of the rack enclosure.
Attention:
• Two or more people are required to remove the system from a rack cabinet.
• To completely remove the server from the rack, press the latches on the sides on the slide rails.
000
000
00000
00000
00000
00000
00000
000000
000000
000000
0
Half-out latch
320
Lenovo System x3630 M4 Installation and Service Guide