Lenovo System x3630 M4, Installation And Service Manual

Page: 195 / 1050

Rotating the optional hot-swap rear hard disk drive cage up
Use this information to rotate the optional hot-swap rear hard disk drive cage up.
To rotate the optional hot-swap hard disk drive cage up, complete the following steps.
Step 1. Read the safety information that begins in “Safety” on page v and “Installation guidelines” on
page 36.
Step 2. Turn off the server (see “Turning off the server” on page 26) and all attached peripheral devices.
Disconnect all power cords; then, disconnect all external cables as necessary to replace the device.
Step 3. Remove the server top cover (see “Removing the server top cover” on page 320
Step 4. Open the two respective blue latches on the chassis 1 .
Step 5. Slowly rotate the rear hard disk drive cage outwards until it stops 2 .
Step 6. Shift the switch on the rear hard disk drive cage to the lock position to keep the hard disk drive
cage fixed
3 .
00
00
00
00
00
00
00
00
0
00
00000
00000
00000
00000
00000
000
000
3
1
2
1
Release latch
Rotating the optional hot-swap rear hard disk drive cage down
Use this information to rotate the optional hot-swap rear hard disk drive cage down.
To rotate the optional hot-swap hard disk drive cage down, complete the following steps.
Step 1. Read the safety information that begins in “Safety” on page v and “Installation guidelines” on
page 36.
Step 2. Shift the switch on the rear hard disk drive cage to the unlock position 1 .
Step 3. Slowly rotate the cage downwards until it sits into place 2 .
Step 4. Close the blue latches on the chassis 3 .
Chapter 6
.
Removing and replacing components
181