Lenovo RackSwitch G8332, Command Reference Manual

Page: 655 / 776

© Copyright Lenovo 2016 Chapter 4: Configuration Commands
655
echo ­ reply ­ timeout
<2 ‐ 65535>
Configures the duration in seconds the switch will wait to receive an echo
reply from the controller, before assuming failure.
The default value is
15
seconds.
Note: The
echo ­ reply ­ timeout
value must be lower than the
echo ­ request ­ interval
value.
Command mode : OpenFlow Instance
no echo ­ reply ­ timeout
Resets the
echo ­ reply ­ timeout
to the default value of
15
seconds.
Command mode : OpenFlow Instance
echo ­ request ­ interval
<5 ‐ 65535>
Configures the maximum duration in seconds the switch will keep sending
echo requests to a non ‐ responsive controller.
The default value is
30
seconds.
Note: The
echo ­ request ­ interval
value must be higher than the
echo ­ reply ­ timeout
value.
Command mode : OpenFlow Instance
no echo ­ request ­ interval
Resets the
echo ­ request ­ interval
to the default value of
30
seconds.
Command mode : OpenFlow Instance
[no] edgeport
<port alias or number>
Enables or disables the selected port as an OpenFlow edge port (outside port).
Edge ports are usually connected to servers.
The default setting is
disabled
.
Note : Learning and flood blocking are turned on in OpenFlow edge ports.
Command mode : OpenFlow Instance
[no] edgeport portchannel
<1 ‐ 208>
Enables or disables the selected portchannel as an OpenFlow edge portchannel
(outside portchannel). Edge portchannels are usually connected to servers.
The default setting is
disabled
.
Note : Learning and flood blocking are turned on in OpenFlow edge
portchannels.
Note: Supported only in OpenFlow 1.3.
Command mode : OpenFlow Instance
Table 374.
OpenFlow Configuration Options (continued)
Command Syntax and Usage