Lenovo RackSwitch G8332, Command Reference Manual

Page: 673 / 776

© Copyright Lenovo 2016 Chapter 4: Configuration Commands
673
USB Copy
If a USB drive is inserted into the USB port, you can copy files from the switch to
the USB drive, or from the USB drive to the switch. You also can boot the switch
using software or configuration files found on the USB drive (see “USB Boot
Configuration” on page 693 ).
Copy to USB
Use the following command to copy a file from the switch to the USB drive:
usbcopy tousb
<filename>
{active|boot|crashdump|image1|image2|
|syslog}
Command mode : Privileged EXEC
In this example, the active configuration file is copied to a directory on the USB
drive:
Copy from USB
Use the following command to copy a file from the USB drive to the switch:
usbcopy fromusb
<filename>
{active|boot|image1|image2}
Command mode: Privileged EXEC
In this example, the active configuration file is copied from a directory on the USB
drive:
The new file replaces the current file.
Note: Do not use two consecutive dot characters ( .. ). Do not use a slash character
( / ) to begin a filename.
RS G8332# usbcopy tousb a_folder/myconfig.cfg active
RS G8332# usbcopy fromusb a_folder/myconfig.cfg active