Lenovo RackSwitch G8332, Command Reference Manual

Page: 383 / 776

© Copyright Lenovo 2016 Chapter 4: Configuration Commands
383
Management Network Configuration
These commands are used to define IP address ranges which are allowed to access
the switch for management purposes.
Note: Management ACLs filter traffic received through data interfaces only.
Management interface is not monitored.
default access tftp ­ port
Resets the TFTP port to the default port number ‐
69
.
Command mode: Global configuration
[no] access tsbbi enable
Enables or disables Telnet/SSH configuration through the Browser ‐ Based
Interface (BBI).
Command mode: Global configuration
[no] access userbbi enable
Enables or disables user configuration access through the Browser ‐ Based
Interface (BBI).
Command mode: Global configuration
show access
Displays the current system access parameters.
Command mode: All
Table 165.
System Access Configuration Options (continued)
Command Syntax and Usage
Table 166.
Management Network Configuration Options
Command Syntax and Usage
[no] access management ­ network
<mgmt network IPv4 address>
<mgmt network IPv4 netmask>
Adds or removes a defined network through which switch access is allowed
via Telnet, SNMP or the Enterprise NOS browser ‐ based interface. A range of
IPv4 addresses is produced when used with a network mask address. Specify
an IPv4 address and mask address in dotted ‐ decimal notation
Note : If you configure the management network without including the switch
interfaces, the configuration causes the Firewall Load Balancing health checks
to fail and creates a “Network Down” state on the network.
Command mode: Global configuration
[no] access management ­ network
<mgmt network IPv4 address>
<mgmt network IPv4 netmask>
{snmp ­ ro|snmp ­ rw}
Adds or removes a defined IPv4 network through which SNMP read ‐ only or
SNMP read/write switch access is allowed. Specify an IPv4 address and mask
address in dotted ‐ decimal notation.
Command mode: Global configuration