Lenovo RackSwitch G8332, Command Reference Manual

Page: 654 / 776

654
G8332 Command Reference for ENOS 8.4
[no] buffer
Enables or disables buffering support for OpenFlow packets.
The default setting is
disabled
.
Command mode : OpenFlow Instance
connect ­ retry
<1 ‐ 8>
Configures the maximum number of attempts to establish connection to a
controller, before assuming the controller is down.
The default value is
4
.
Command mode : OpenFlow Instance
no connect ­ retry
Resets the
connect ­ retry
value to 4.
Command mode : OpenFlow Instance
controller
<1 ‐ 4>
address
<IP address>
[data ­ port|mgt ­ port]
Configures the IP address of the OpenFlow Controller. You may specify the
port to use for data transfer: data port (
data ­ port
) or management port
(
mgt ­ port
).
By default, the system uses the management port.
Command mode: OpenFlow Instance
controller
<1 ‐ 4>
port
<
TCP port number (
1 ‐ 65535)>
Configures the TCP port used for communication with the Controller.
The default port is
6633
.
Command mode: OpenFlow Instance
no controller
<1 ‐ 4>
Deletes the selected controller from the specified instance ID.
Command mode : OpenFlow Instance
dpid
<hex string>
Applies an 8 byte Datapath ID to the instance, which uniquely identifies an
OpenFlow instance in an OpenFlow environment.
The default value is the instance ID followed by the switch MAC.
Note: The Datapath ID must be unique among the switches controlled by a
single OpenFlow controller.
Command mode : OpenFlow Instance
no dpid
Resets the instance’s Datapath ID to the default value (instance ID followed by
the switch MAC).
Command mode : OpenFlow Instance
Table 374.
OpenFlow Configuration Options (continued)
Command Syntax and Usage