Lenovo RackSwitch G8332, Command Reference Manual

Page: 552 / 776

552
G8332 Command Reference for ENOS 8.4
OSPFv3 Virtual Link Configuration
The following table describes the OSPFv3 Virtual Link commands.
Table 291.
OSPFv3 Virtual Link Configuration Options
Command Syntax and Usage
area ­ virtual ­ link
<1 ‐ 3>
area
<0 ‐ 2>
Configures the OSPF area index.
Command mode : Router OSPF3
area ­ virtual ­ link
<1 ‐ 3>
dead ­ interval
<1 ‐ 65535>
Configures the time period, in seconds, for which the router waits for hello
packet from the neighbor before declaring this neighbor down.
Command mode : Router OSPF3
[no] area ­ virtual ­ link
<1 ‐ 3>
enable
Enables or disables OSPF virtual link.
Command mode : Router OSPF3
area ­ virtual ­ link
<1 ‐ 3>
hello ­ interval
<1 ‐ 65535)>
Configures the indicated interval, in seconds, between the hello packets, that
the router sends on the interface.
Command mode : Router OSPF3
area ­ virtual ­ link
<1 ‐ 3>
neighbor ­ router
<NBR router ID (IP address)>
Configures the router ID of the virtual neighbor.
The default setting is
0.0.0.0
.
Command mode : Router OSPF3
area ­ virtual ­ link
<1 ‐ 3>
retransmit ­ interval
<1 ‐ 3600>
Configures the interval, in seconds, between link ‐ state advertisement (LSA)
retransmissions for adjacencies belonging to the OSPFv3 virtual link interface.
The default value is
5
seconds.
Command mode : Router OSPF3
area ­ virtual ­ link
<1 ‐ 3>
transmit ­ delay
<1 ‐ 3600>
Configures the estimated time, in seconds, taken to transmit LS update packet
over this interface.
Command mode : Router OSPF3
no area ­ virtual ­ link
<1 ‐ 3>
Deletes OSPF virtual link.
Command mode : Router OSPF3
show ipv6 ospf area ­ virtual ­ link
Displays the current OSPFv3 virtual link settings.
Command mode : All