LeCroy DDA 7 Zi series, Operator'S Manual

Page: 506 / 544

WavePro 700Zi
505
WP700Zi-OM-E-RevA
WavePro Zi WaveMaster SDA DDA
Oscilloscope
Compatibility 715, 725, 735, 740, and
760 models.
8300, 8300A, 8500,
8500A, 8600A, and
8620A including all
WaveMaster XXL
models.
SDA 3000, 3000A,
5000, 5000A, 6000,
6000A, and 6020
including all SDA XXL
and 700Zi models.
DDA 5005A, 5005A
XXL, and DDA 700Zi
Oscilloscope
Connection
ProLink
Probes
Supported D610,D620, D600A-AT, D310, D320, and D300A-ATwith all probing accessories AP020,
AP033, AP034 HFP1000, 1500, 2500, and 3500 PP005 and PP005A
DC Range ±5 V single-ended, ±10 V differential
DC Accuracy ±(1% + 600 V)
Edge Risetime
75 ps (typical) < 95 ps (guaranteed)
Edge Amplitude
and Rep Rate
Approximately 800 mV @ 10 MHz
Deskew
Accuracy
±20 ps (typical)
Probe calibration is accomplished with the TF-DSQ fixture by following the basic
steps in the flowchart at left. It is recommended that you read the instructions
presented here in their entirety to familiarize yourself with the advanced features
of the TF-DSQ fixture.
The combination of TF-DSQ fixture and scope software is designed with an
important use model. Connecting probes to the circuit under test can be a
difficult procedure. LeCroy's system, therefore, is designed in a manner that
allows you to set up the probe calibration fixture, calibrate each individual probe
once, connect your probes to the circuit, and disconnect the fixture. Once your
probes are in the circuit, there is no need to revisit the fixture until the next
calibration interval.
You should familiarize yourself with the following topics:
TF-DSQ fixture overview
TF-DSQ Scope connection
Probe Calibration Menu access
Probe connection to fixture
Calibrating probes