LeCroy DDA 7 Zi series, Operator'S Manual

Page: 44 / 544

WavePro 7Zi
43
WP700Zi-OM-E-RevA
x
Absolute Cursor - Press to set the cursor position to the default 25% position, either horizontal or vertical
(depending on which cursor type your are using). Turn to adjust the position of the cursor (absolute cursor
or one of the two relative cursors).
x
Cursor Type - Press one to turn cursors ON to the last cursor type selected. Each subsequent press
toggles through the cursor types ( Off , Abs Horizontal , Rel Horizontal , Abs Vertical , or Rel Vertical ).
x
Relative Cursor - Press to set the relative cursor to the default 75% position, either horizontal or vertical
(depending on which cursor type you are using)Turn to adjust relative cursors. It does not work with
absolute cursor types.
WaveScan Front Panel Controls
Note: WaveScan front panel controls correspond with screen menu selection: Analysis WaveScan .
x
Scroll - If WaveScan is On, turn to scroll through the table of WaveScan-filtered events. If WaveScan is
Off, turn to adjust the selected data entry field.
x
On/Off - Press to toggle between WaveScan On and Off. This is the same as checking Enable in the
WaveScan dialog. When you turn WaveScan On, it turns on the WaveScan to the last enabled mode on
the last selected Channel with the last selected Filter method. It also turns on the Z1 trace with its source
as the WaveScan Channel and changes whatever display grid was selected to a dual grid with channels in
the top grid and the WaveScan Z1 trace in the bottom grid.
x
Setup - Press once to open the WaveScan dialog. Corresponds with screen menu selection: Analysis
WaveScan . Press the WaveScan S
ETUP
front panel button again to close the WaveScan dialog.