Larsen & Toubro C*2000 Series, User Manual

Page: 3 / 183

Safety Instructions
ii
Cx2000 AC Drive
 Wiring and periodic inspections should be performed at least 10 minutes after
disconnecting the input power and after checking the DC link voltage is discharged with a meter
(below DC 30V).
Otherwise, you may get an electric shock.
 Operate the switches with dry hands.
Otherwise, you may get an electric shock.

Do not use the cable when its insulating tube is damaged.
Otherwise, you may get an electric shock.
 Do not subject the cables to heavy loads.
Otherwise, you may get an electric shock.
CAUTION
 Install the inverter on a non-flammable surface.
Do not place flammable material nearby. Otherwise, fire could occur.
 Disconnect the input power if the inverter gets damaged.
Otherwise, it could result in fire.
 Do not touch the inverter if it is supplied with electricity or the power is cut off for a few
moments.
Because the inverter is under high temperature status, it may cause scald.
 If the inverter is damaged or the part is damaged, do not operate the inverter even if the
installation is complete.
Otherwise, electric shock could occur.
 Do not allow screw, metal, water, other conductive objects, oil and flammable objects into the
inverter.
Otherwise, fire could occur.
[WARNING]
Risk of injury or Electric Shock: Read the manual and follow the safety instruction before use.
Risk of Electric Shock: More than one disconnect switch may be required to de-energize the equipment before
servicing.
Risk of Electric Shock: Before opening the cover, disconnect all power and wait at least 10 minutes.
Risk of Electric Shock: Securely ground (earth) the inverter
.