![background image](http://html2.mh-extra.com/html/landoll/bendi-b40i4/bendi-b40i4_maintenance-manual_3515299017.webp)
INTRODUCTION, SAFETY AND INSPECTION
1-11
To be performed each 300 hrs of truck operation in addition to the required pre-shift daily inspection
Technicians 300 Hour Inspection
Status
Landoll / Bendi IC
SAFETY & OPERATIONAL CHECKS
Have a qualified technician correct all problems.
OK - Yes,No
Maintenance Note if Applicable
Mast, carriage, or attachment friction surfaces - Clean,
inspect for wear or damage, and lubricate.
Lift chains - Clean and lubricate.
Extend mast - Check for excessive wear.
Attachment control - Operational.
Rotation Bearings - Retorque to 30 ft-lbs (40.7 Nm)
Front Wheel Bearings - Clean and fill with grease.
Accelerator - Functioning smoothly.
Controls (turn power on); Investigate unusual noises
immediately.
Instrument monitors - Functioning.
Air Cleaner Element - Clean.
Hydraulic fluid level - Check and fill.
Vacuum Hoses - Check for cracks and leaks.
Exterior of hydraulic Tank and Oil Tank Breather - Clean.
Engine Compartment - Clean.
Engine Oil and Filter - Replace.
Alternator and Starter - Clean with compressed air;
Check brushes and springs, check power terminals.
Battery - Thoroughly clean case and connectors.
Muffler and Exhaust System - Check for leaks.
LPG System - Check pressure hoses and fitting seals.
Radiator - Use air to clean fins; correct cap and tighten;
check hoses and clamps for leaks.
Seat belt, buckle, and retractors - Functioning smoothly.
Tire - Check for debris,torque lug nuts to 225 ft-lbs (300
Nm).
Load wheel bearings - Clean and fill with grease.
Leaks - Hydraulic oil, Battery, Engine Oil, Engine
Coolant.
Hydraulic hoses and connections - Check for wear.
Switches (interlock, direction, parking/seat, key,
pressure, and temperature) - Check.
Wire connections and sending units - Check.
Grease fittings - Service.
Tighten Overhead Guard Bolts - 170 fT-lbs(230 Nm).
Date
Inspector:
Truck No.
Model No.
Location
Serial No.
Shift
Hr Meter
Battery Fluid
Hydraulic Oil
Summary of Contents for Bendi B40i4
