Landoll Bendi B40i4, Maintenance Manual

Page: 118 / 142

4-18 F-581-R1
CALIBRATION AND PROGRAMMING
Figure 4-27: Vehicle Fault Screen
7. For Calibration of forklift functions first press the
“SETUP” button located at the bottom of the display.
See Figure 4-25.
NOTE
Read and understand through page 4-16 before
continuing.
Figure 4-28: Setup Screen One
Setup screen 1 will allow you to set the clock and
calibrate the steering settings. When completed with
setup screen 1 and the steering is calibrated, press
”NEXT” to proceed to “SETUP SCREEN 2” which will
allow you to calibrate the drive pedal and tilt lever
functions. See Figure 4-28.
IMPORTANT
At any time, with any of the three “SET STEER”, “SET
PEDAL” and/or “SET LIFT” settings if you require
direction or assistance, select the “HELP” button
and the steps required to complete that section of
calibration will appear on the screen. See
Figure 4-29. See Figure 4-30, showing the “SET
STEER” function.
NOTE
In order to set the steer sensor, the engine must be
running and the parking brake disengaged.
Figure 4-29: Set Steer Sensor Screen
Figure 4-30: Set Steer Help Screen