Landoll Bendi B40i4, Maintenance Manual

Page: 107 / 142

CALIBRATION AND PROGRAMMING
4-7
Figure 4-9: Faults Screen
“FAULTS SCREEN” showing added functions monitored
Below is provided a definitions list for forklift
parameters: See Figure 4-9.
1. 0,3-CP_J1939_OFFLINE – Displays CAN status, Off
= communicating, On = Lost communication.
2. 0,3-CP_LiftSpool_Flt – Displays status of lift pot,
Off = systems ok, On = Pot shorted, open, or faulty.
3. 0,3-CP_LiftSpool_mV – Displays pot wiper voltage.
4. 0,3-CP_LiftSpool_NoCal – Displays calibration
status, Off = calibration ok, On = no calibration.
5. 0,3-CP_Pedal_Flt – Displays status of accel pot, Off
= systems ok, On = Pot shorted, open, or faulty.
6. 0,3-CP_PumpFwdRevFlt - If forward and reverse
are at the same time PumpFwdRevFlt will be active.
7. 0,3-CP_Pedal_mV – Displays pot wiper voltage.
8. 0,3-CP_REV_EDC_FLT - Displays status of valve
coil, Off = systems ok, On = coil, shorted, open, or
faulty.
9. 0,3-CP_FWD_EDC_FLT - Displays status of valve
coil, Off = systems ok, On = coil, shorted, open, or
faulty.
10. 0,3-CP_Steer_Flt – Displays status of accel pot, Off
= systems ok, On = Pot shorted, open, or faulty.
11. 0,3-CP_Steer_mV – Displays pot wiper voltage.
12. 0,3-CP_SeatTimeOut – Displays status of seat
switch with delay, Off = seat switch is made and
satisfied, On = seat switch not made due to short or
open.
13. 0,3-HydTemp_FLT – Displays status of
Temperature sensor, Off = systems ok, On = Short
high, short low, or open.
14. 0,3-CP_Fan_Fault - Displays status of fan valve coil,
Off = systems ok, On = coil, shorted, open, or faulty.
15. 0,3-C1p27.Ohm – Displays resistance of Hydraulic
temp sensor.
16. 0,3-CP_Lower_FLT - Displays status of lift
secondary bypass lift valve, Off = systems okay, On
= coil shorted, open, or faulty