3-10
F-581-R1
TROUBLESHOOTING AND CORRECTIVE MAINTENANCE
Cont’d
Blown horn fuse.
•Check for electrical short - in horn
or electrical connections.
Rubbing noise from the front
wheels.
Faulty wheel bearing or damaged
wheel shaft.
• Dismount suspected wheel and
examine bearings and shaft.
• See “Wheel Bearings, Seals, and
Races,” on
• Check for foreign material lodged
inside wheel hub - remove and
repair and/or replace as needed.
Scraping noise when the mast is
operated
NOTE
All mast warranty is done by Lift-tek
if applicable. Please call 888-liftek.
Out of alignment.
Faulty hydraulic cylinder - lift, tilt
and/or shift.
Needs lubrication.
• Realign and shim mast rails
accordingly.
• Determine which cylinder is bad -
rebuild or replace.
• Seal kits are available for most
cylinders - see Mast Parts List(s)
F-387 or F-389 for replacement
items.
• Lubricate mast as described in
Chapter 2,
Planned Maintenance.
Problem
Cause
Suggested Repair
Summary of Contents for Bendi B40i4
