4-16
F-581-R1
CALIBRATION AND PROGRAMMING
Figure 4-21: Fan Screen
Fan Screen
The “FAN” screen shot provides featured parameters for
the Plus 1 functions. See Figure 4-21.
Below is provided a definitions list for forklift
parameters: See Figure 4-21.
1.
0,3-MaxFanCur
– Pre defined in software, for
reference only.
2.
0,3-MinFanCur
– Pre defined in software, for
reference only.
3.
0,3-FanRampUp
– Pre defined in software, for
reference only.
4.
0,3-FanRampDown
– Pre defined in software, for
reference only.
5.
0,3-HydTempFanMax
– Pre defined in software, for
reference only.
6.
0,3-HydTempFanMin
– Pre defined in software, for
reference only.
7.
0,3-EngTempFanMax
– Pre defined in software, for
reference only.
8.
0,3-EngTempFanMin
– Pre defined in software, for
reference only.
Dash Display Calibration and
Operation
CAUTION
Before starting to operate the forklift, for safe forklift
operation, monitoring and performance testing:
• Be in a safe operating position.
• Apply parking brake.
• Place directional control in neutral.
To operate the forklift and begin Dash Display
Calibration:
1. The ignition switch must be on, but the engine does
not need to be running at this point. Later in step #6
you will need to then start the engine.
2. The display shown below will be shown with the
ignition on, before the forklift is started. See
Figure 4-22.
Figure 4-22: Display When Ignition On, Forklift Not
Started
3.
After the forklift is running and when the forklift and
system are functioning correctly the row of “Icons”
across the top of the “System Active” screen will not
be seen. Each warning icon is described for your
future reference. See Figure 4-23.
While Calibration you will be operating many
functions of the forklift and it is imperative that
you position the forklift in an area without
obstructions or personnel, that may be injured or
product damaged.
Summary of Contents for Bendi B40i4
